SIFAT PEMESINAN 34 JENIS KAYU DARI MALUKU & SULAWESI TENGAH

Osly Rachman, Jamal Balfas

Abstract


The machining properties of  34 wood  species  tested according to the ASTMD 1666-64  procedure are presented in this paper.  The machining  properties studied  were planing,  shaping,  turning,  sanding,  boring and  mortising.

Some of  the species  tested  (such as suling, gohimahou etc.)  are consistently better  than average in most  respects  and some  are consistently poorer  (such as telor, andolia etc.).  Some  are good  in one property or two and poor in others.  These differences are probably due to differences in the specific gravity  values of  each species

Keywords


Machining properties; wood species; consistently; procedure

References


Anonymus, 1974. Standard Method of Machining Test and Wood Base Material. Annual Book of ASTM. Philadelphia.

Akub. J.A. dan Karnasudirdja. S, 1982. Sifat Pemesinan Kayu - Kayu Indonesia. Laporan BPHH No. 160. Bogor.

Koch. P, 1964. Wood Machining Process. The Ronald Press Co. New .York.

Oey Djoen Seng, 1964. Berat Jenis dari jenis-jenis kayu Indonesia dan pengertian berat kayu untuk keperluan praktek. Pengumuman LPHH No.1. Bogor.

Untung. S.A, 1984. Studi pendugaan sifat pemesinan kayu melalui beberapa sifat fisis, mekanis dan anatomisnya. Skripsi. Fakultas Kehutanan, IPB. Bogor.




DOI: https://doi.org/10.20886/jphh.1985.2.3.27-36

Refbacks

  • There are currently no refbacks.


JURNAL PENELITIAN HASIL HUTAN INDEXED BY:

More...


Copyright © 2015 | Jurnal Penelitian Hasil Hutan (JPHH, Journal of Forest Products Research)

eISSN : 2442-8957        pISSN : 0216-4329

       

JPHH is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.