SIFAT PEMESINAN 10 JENIS KAYU DARI DAERAH NUSA TENGGARA BARAT

Osly Rachman, Sri Rulliaty

Abstract


Machining  properties  of  ten  wood  species from West Nusa Tenggara is reported  in this paper.The sample material was tested under ASTM D-1666 that was modified   according to  Forest Products Research  Institute Report No.160 (1982). The  samples (25  pieces/species) were  dried  to  equilibrium   moisture content condition (15 to18 %  of  MC). The  machining  properties   tested  are planing,  shaping,  boring,  turning,  and sanding.

Four species  that have good  to  very good  machining properties  are Anthocephalus cadamba  Miq., Duabanga moluccana BL., Eugenia longiflora (Presl.) F. Viii., and  Eugenia polyantha Wight. Whereas the other species have poor  machining properties   i.e.,  Ailanthus  malabarica DC, Ficus  microcarpa   L.f  and  Palaquium  javense Burck.


References


ASTM, 1974. Standard method of conducting machining test of wood based material. Annual Book of ASTM, Philadelphia

Abdurachman, A.J. dan S. Karnasudirdja, 1982. Sifat pemesinan kayu-kayu Indonesia. Laporan BPHH no.160. Bogor.

Anonim, 1978. Tree Flora of Malaya. A manual for Forester vol III. Malayan Forest Records 26, FRI Kepong.

Oey Djoen Seng, 1964. Berat jenis dari jenis-jenis kayu Indonesia dan pengertian Berat Jenis kayu untuk keperluan Praktek. Pengumuman LPHH no.1, Bogor.

Rachman, O. 1989. Himpunan sifat pemesinan jenis-jenis kayu Indonesia. Tidak diterbitkan. Dokumentasi Disiplin Penggergajian dan Pengerjaan. Puslitbang Hasil Hutan, Bogor.




DOI: https://doi.org/10.20886/jphh.1990.7.4.121-129

Refbacks

  • There are currently no refbacks.


JURNAL PENELITIAN HASIL HUTAN INDEXED BY:

More...


Copyright © 2015 | Jurnal Penelitian Hasil Hutan (JPHH, Journal of Forest Products Research)
eISSN : 2442-8957, pISSN : 0216-4329
JPHH is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.