PENGARUH PENGERASAN MATA GERGAJI DAN POLA PENGGERGAJIAN TERBADAP. KARAKTERISTIK PENGGERGAJIAN KAYU SENGON (Paraserianthes falcataria)

Osly Rachman

Sari


This paper deals  with  the study of charaetmstlc  and sawing recovery of sengon  (Peraserianthes falcataria). The materials used in  this study consiat  of  12c logs with 200 cm long and diameter ranging from 35,5 -36,5   cm.  Three types. of  sawtooth edge profile. were  prepared  to saw the logs, i.e. full stellite tipped, alternate-one stellits tipped and alternate –twostellitetipped. the power consumption and feed aped produced by each type of sawtooth were observed and analysed. in the study of sawn timber production two sawing patterns were applied.the parameters investigsted compriss recovery, productivity, board composition and visual defect,

results of the study revsal that saw blade with alternate two steliite tipped consumes the lowest power and its feeding speed is the highest. in addition the semi quarter sawing yields recouery 4.5 % higher than live sawing pattern.meanwhile.the sawing productivity between two sawing patterns is not significantly different. the live sawing pattern produces 61 % boards of 15 and 17,5 cm wide; whereas semi quarter sawing produces 42% boards of 10 and 12,5cm. wide. the main defects of boards are knots,splits and shakes. 


Teks Lengkap:

PDF

Referensi


Anonim. 1958. Hutan lndustri. Panitia Peraneang Hutan

lndustri. Jawatan Kehutanan, Jakarta.

---. 1976. Vademicum Kehutanan Indonesia. Direk-

torat Jenderal Kehutanan,.Jakarta.

---. 1979. Tropical Legumes, Resourcea for the Fu-

ture. National Academy of Science, Washington D.C. Koch, P. 1964. Wood Machining Proceas. The Ronald Press

Company. New York

Martawijaya, A. dan I. Kartuujana. 1977. Ciri umum, Slfat

dan Kegunaan Jenis-jenis Kayu lndoneaia. Publikasi Khu-

sus No. 41. Lembaga Penelitian Hasil Hutan, Bator.

Rachman, 0. 1989. Pengaruh pengerasan mata gergaji dan

pola penggergajian terhadap kharakteristik penggergajian

kayu karet. Journal Penelitian Hasil Hutan 6( 5) : 318 -

Schrewe, H. 1986. Sawmillng Researeh and Induatry In

Malaysia and Thailand With possible application to other asean countries. FAO working paper No. 44, kuala lumpur.

widodo, S. 1985. pengenalan cacat kayu gergajian indonesi. ditjen pengusahaan hutan, departemen kehutanan, Jakarta.




DOI: https://doi.org/10.20886/jphh.1991.9.4.163-169

Refbacks

  • Saat ini tidak ada refbacks.


JURNAL PENELITIAN HASIL HUTAN TERINDEKS DI:

Lebih banyak...


Copyright © 2015 | Jurnal Penelitian Hasil Hutan (JPHH, Journal of Forest Products Research)
eISSN : 2442-8957, pISSN : 0216-4329
JPHH is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.