PENETAPAN UKURAN SASARAN SEBAGAl SUATU CARA PENGENDALIAN KUALITAS DI KILANG PENGGERGAJIAN

Sutarso Priasukmana, Sylviani Sylviani, Unang Suratman

Sari


A  study   of  quality  control application on  sawn-timber  was   conducted  on  several sawmills in  Sumatra, West Kalimantan and East Kalimantan. Sample sawmills are selected based   on  market orientation and the availability of drying facibilities.

The objectives of this study are to introduce new methode of quality control for sawn timber, in this target sise determination, and to evaluate the quality control practices in exitng' sawmill operationt.

The results of the study show that all the sampled sawmills did not have a apecific program of quality control, nor special personnels responsible for quality control.

Green board thicness set by surveyed sawmills were higher than what is actually reguired, ranging  between  1  to 23 percent above the calculated target size. This is an indication that there is  a  lot of room improving the efficiency of raw material usqge through the application of target size settling  formula.                                                            


Kata Kunci


introduce;surveyed;results;determination

Teks Lengkap:

PDF

Referensi


BROWN, T.D. 1982. Quality Control in Lumber Manufac-

turing. Miller Freeman Publ. San Fransisco.

PRIASUKMANA, 8. 1983. Program pengendalian kualitas unuk peningkatkan efisiensi dan Pengembangan Pemasaran Kayu Gergajian.Proceding Diskusi Industri Hasil Hutan, Bogor.

WHITEHEAD, J.C. 1978. Prosedures tor Developing a

Lumber-size Control System. Inf. Ref. VP-X-184.. W.E.P.L. Vancouper, Ca.




DOI: https://doi.org/10.20886/jphh.1986.3.1.1-5

Refbacks

  • Saat ini tidak ada refbacks.


JURNAL PENELITIAN HASIL HUTAN TERINDEKS DI:

Lebih banyak...


Copyright © 2015 | Jurnal Penelitian Hasil Hutan (JPHH, Journal of Forest Products Research)
eISSN : 2442-8957, pISSN : 0216-4329
JPHH is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.